Product has been added to your cart.

828 schematic/parts

Home › Forums › Ask Ted › 828 schematic/parts

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • September 25, 2009 at 6:36 am #15199
    shred
    Participant

    Hi,
    Could I please have a schematic for an 828?
    I need to source and replace a few gain antilog pot’s – any ideas/prices?
    Any idea of the value of these today?
    Thanks

    September 25, 2009 at 7:53 am #15563
    Ted Fletcher
    Keymaster

    I can certainly let you have the schematics for the 828, but I only have details of the series 2 version…. but that’s likely to be the one you have.
    As for pots, these were ‘Omeg’ pots and I don’t use them or hold any stocks any more, but you might find them in RS or Farnell.
    I will email you the circuits and layouts. :)

    October 12, 2009 at 3:47 pm #15564
    PhanTom
    Participant

    Hi!

    I’m from Hungary and speak very little English. Sorry.

    I have a Alice 828 (MHF 24-1-83, SN: 777-2357), but unfortunately it does not work. Maybe any IC (HAI-4741-5) broke. An alternative would like to ask us for this IC is unknown. As can be replaced?
    It would be nice to have a schematic, to see the connections as.

    Best Regards

    Thomas

    October 14, 2009 at 8:15 am #15565
    Ted Fletcher
    Keymaster

    Hi Thomas, the IC you talk about is the Harris 4741 and it is probably difficult to source now. It is simply a quad version of the 741 and has the same connections as the TL074, and you could probably replace it directly with the TL074.
    I will email separately with the circuit diagrams. :)

    October 14, 2009 at 8:42 am #15566
    PhanTom
    Participant

    Dear Ted,

    thanks to Your Information and email. Great Help for me!

    Kind regards

    Thomas

    October 16, 2009 at 2:34 pm #15567
    PhanTom
    Participant

    Hi!

    Again here. I swapped each IC. Only the 4016 has not been replaced. Now it works, but …
    Normal mode, only the right side reads, PFL mode, only the left side. Maybe the 4016? I don’t know.

    Kind regards

    Thomas

    October 16, 2009 at 2:50 pm #15568
    Ted Fletcher
    Keymaster

    Yes, that sounds very much like a fault in the 4016…. this is used as the change-over switch in the PFL circuit, so that would be it. 😥
    But you are getting there! :)

    October 16, 2009 at 2:55 pm #15569
    PhanTom
    Participant

    Thanks Ted!

    Exchanged and I’ll tell you the results! This is a very good desk, I like! It would be nice to work with him again :-)

    Thomas

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.