Forum Replies Created
-
AuthorPosts
-
But one little question remains: as you can see in the lower left corner of the photo my VC3Q got no Microphone-Switch as the P3.
What is the difference?
Can I use Microphone-In and Line-In at the same time?
I don’t need it, but what is the switch for? As my VC3Q sounds with a
german Sandberg Bullet Special 6 like a Fender Jazzbass or even like
a Fender Stratocaster. I love this wonderful sound.
If I can reach one I will try a VC3 too.
Thank you for your Equipment, it’s splendid.
(And I cannot believe that I am writing with the man who did it!
) Thank you very much, that’s very kind! Kind regards!
Thank you! Thank you for the answer, I was in doubt… But on the other hand I was shure that my P2 could handle it.
It is the best Audio-Gear I ever bought.
Why did you doubt the 1000 ohms?
Can I measure it? Sorry but I am not a pro!
😯 I am a musician and not understanding all the numbers of ohms and dB and so on.
In the manual of my TFPro P2 I can read the following: MICROPHONE INPUT · XLR Input 800 ohm approx. current mode to suit 200 ohm microphones.
Now I bought two AKG C3000B, which have 1000 Ohm.
What does this practically mean for me an the use with the P2?
Thank you!
Ted thank YOU very much for this bounteous offer.
I will send it when I expect I can renounce this wonderful Unit
of Music- and Tone-manipulation.
Either I wait until the second VU-Unit fails?Thank you again,
your units are wonderful exactly working Music-Tools! -
AuthorPosts